This was the weekend project: The Akatsuki cloak for my stepdaughter Rachel.
I had decided not to do the dimensional paint on it when I realized the clouds didn't really need to be outlined, and it would have added to the cost of the project.
I worked on the clouds first, which you can find the details on in a previous post.
Instead of using a pattern, I did it a way that I saw at a few sites where one wasn't required.
1) Measure from the shoulder to mid-shin, and add 2 inches. Cut the black and red fabric at that length, then sew the two pieces together at the sides only. Sew only at the sides and turn inside out.
2) Measure from one side of the collarbone to the other, then add an inch. Cut this hole on the middle of the piece you just sewed. You will probably want to sew the neckline at this point to reinforce it..
3) Using your wearer as a mannequin, measure from the edge of the fabric to the tip of the fingers. Add 2 inches. Then measure around the wrist to where you want the sleeve cuff to hang, and add an inch. Have your mannequin take off the cloak.
4) Cut the lining and sleeve and sew together on the short edges. Sew with black side facing on the middle of the fabric piece on either side.
5) Have your mannequin put the cloak on again, and pin together the sides and sleeves. Sew and turn around.
6) Cut down the middle of the front. of the cloak. Baste lining and outside together.
7) Measure from the nose to the collar on the wearer, and add an inch. Cut a rectangular piece from both outside and lining as long as the collar and as high as the nose to collar measurement, adding an inch.
8) Place the fabric on fusible interfacing, using an iron on medium heat to fuse the interfacing to the fabric. Cut from the interfacing.
9) Sew the two pieces right sides facing each other, interfacing facing out, along the top only. Turn inside out and iron. Sew on to collar area.
10) Doing a reverse hem facing out, fold over on the outside about a 1/4 inch, then fold over another 1/4 inch, then pin. Sew with red thread.
11) Hem the bottom about an inch, then sew.
12) Iron on the clouds in the placement in the previous post, then sew around the edges to keep from curling.
13) Wash, dry, and you're done!
If I ever have to make this cloak again I'm going to try it with a pattern next time, because I think I actually found it harder doing it without one.
Thoughts?
